Recent content by burick701

it turned out great. thanks for all your guys help.

ok thanks that helped a lot. appreciate all your help and patience.

I made 2 terminal cups in my box so I connect - of 1 VC to + of other vc, then - of the 1VC to the - on t-cup. then remaining + to t-cup and just do the same to the other one. right??? do I have to connect the t-cups together at all????

What does "Run those out the first tcup to the tcup on the second sub and do the same thing" mean. Don't I have to connect both subs together though or is that only if I was using 1 terminal cup????

i have 2-2ohm DVC subs that I want to wire at 2ohms. i have seen wiring diagrams like this one http://www.rockfordfosgate.com/rftech/wiringwizard.asp?WoofQty=2+woofers&WoofImp=Dual+Voice+Coil+-+2+ohms+x+2&image.x=25&image.y=14 but if i wire it like this do i need 1 or 2 terminal...

thanks. I wasn't sure how much it should go for. appreciate your help.

would this be good to use to connect my 2 DVC drivers with Voice Coils in Series / Parallel to the terminal cups. http://www.radioshack.com/product.asp?catalog%5Fname=CTLG&category%5Fname=CTLG%5F007%5F013%5F000%5F000&product%5Fid=270%2D4140

If I am going to run 2 L5's(600 W RMS each) into a 2ohm load and power it by 1000W @ 2 ohm, how many watts will each sub get??? Is it 500W each or is there so kind of formula depending on what size load you run it at????

Do you really need to fill with polyfill??? Is the sound much different with/without it??? If so how much do you use???

Thanks for the help. I taped all the wires away from the ground and it is working fine. THanks for your help.

what does grounding out mean??? how does that happen???

i'm not sure what fuse it is. It just says radio on the circuit reference. It is the one inside the car under the dash. it is a 7.5A fuse.

I just bought an Alpine 9847 like a week ago. It was running fine and then it blew a fuse. Not on the HU itself but in the circuit box. I replaced it and it worked again. But like a half hour later it turned off again and switched fuse again but it blew again. Took HU out then put it back...

looking to spend around 200-250

dual 2 ohm