Recent content by BTF

Thank you!

Here’s a link to a post on the SSA forum, but no one has responded. If you or anyone else wouldn’t mind looking at the WinISD graphs I posted and give me some feedback, I’d appreciate it! http://www.soundsolutionsaudio.com/forum/topic/73832-gcon-enclosure/?tab=comments#comment-1168454

Thanks Kush! I modeled it in WinISD and at 1500w, port velocity is under 21m/s and excursion reaches max under my subsonic cutoff frequency, so I should be okay, right? Or will the rolloff at cutoff be too slow and cause issues?

If EVERYTHING else stays the same, does port area and/or volume need to be different for different amplifier powers? In other words, if I change from a 1000W amp to a 1500W amp on the same sub, will I need to change any box parameters?

Guilty as charged! I know my next spare $150 should be a DSP.

If only I was smart enough to figure out how to use modeling software 😬😔

Where's the trunk?? 😳😂

No, I mean I don't have the space for 2 of those 612s. I could do 2 610s if I could get them for about $50 off msrp each.

The Alphas need a really big enclosure, so I can't consider them.

Yes but I don't have the space for 2 FI 12s and I can't afford 2 10s ☹️

Thanks Kush, would only be able to do one 12, but I suppose I should consider DD!

Thanks for your reply Lasherž!

Adding subs on a budget and I have it narrowed down to a few, but would like people's opinions on them. Car is an Elantra sedan, factory HU, using a basic LOC for signal. Amp will be a Taramps, model dependent on sub(s). I'll be building a ported enclosure. I listen to a mix of...

Okay, thanks!

That's what I was wondering, thanks! What about putting the port into the corner and the sub firing forward or to the side? Using the same basic box shape and positioning?