Recent content by Bow94z

  1. B

    Having issue with my Eclipse EA4100 shutting off at high volumes

    anyone have any other suggestions on tuning my setup? im still getting some cut out on certain music
  2. B

    Eclipse xa1000... why does shut down when too high of volume???

    What model subs do you have? and how are they wired up inside the box Funny I had a thread the other day about my Ea4100 amp shutting off at high volumes, i had my input too high
  3. B

    Having issue with my Eclipse EA4100 shutting off at high volumes

    i dont understand on this amp why the 8 is the lowest point and 0.2 is the highest point asfar as the input gain:confused:
  4. B

    Having issue with my Eclipse EA4100 shutting off at high volumes

    they are not. i can be siting still and as i go higher with volume, the speakers/amp will shut off...but the subs will continue to the song
  5. B

    Having issue with my Eclipse EA4100 shutting off at high volumes

    Im running a Alpine Cda-9811 headunit with 4volt pre-amp running Eclipse SC6500 comp's (75rms) up front and SE6500 coax's (40rms) in the rear powered by a Eclipse EA4100 amp (75x4) My issue is that my speakers/amp are cutting out when the volume is greater than 16 on my headunit. MAx volume is...
  6. B

    Knukonceptz Karma SS speaker wire is the WORST. Don't use it.

    Wow this is extremely funny because I had just installed Knu's 4 Channel Rca's and chased a speaker cutting out issue for a few days only to find that his Rca end was a piece of Sh*t!!!!!! I used Knu's Rca's like 3-4 years ago in my Camaro and they worked fine. But this time around, i get...
  7. B

    Where do I even start to tune my 6.5" Components??

    I just installed my Eclipse 6.5" SC6500 Components (75rms) with SE6500 rear speakers (40rms). These are attached to a Eclipse EA4100 Amp (75x4) amp. I have a Alpine cda-9811 H/U. Question is, Where do i even start tuning? At the amp or headunit? I understand i adjusted the input levels on the...
  8. B

    powering 6.5 components off of 40rms?

    now my crossovers have jumpers on it i noticed, they are at defaulted in the middle i can either go +3db or -3db shouldi leave at default of 0 i believe? what does this change
  9. B

    powering 6.5 components off of 40rms?

    I thought about that aswell, but i wanted to power the rear SE6500 speakers aswell. i guess im just being cheap and dont want to buy another amp when i have this gm-4300F sittin around I'll try it out see how it works
  10. B

    Downloading music, etc

    http://www.2girls1cup.com
  11. B

    powering 6.5 components off of 40rms?

    anyone else have an opinion running Components @ 40rms? Sc6500's are rated at 75rms
  12. B

    powering 6.5 components off of 40rms?

    I kno the Xplods do ****, i got them free from work and had them in my last car. Whatever i save the money for my Z28 so thats why im goin "cheap" with my dd. otheriwse i'd get nicer subs. Anyways what im asking is, Are these components gonna sound any good with 40watts?
  13. B

    powering 6.5 components off of 40rms?

    I have a 1999 Nissan Maxima, going to be tearing my stock bose system out What im going to be puttin in is Alpine cda9811 H/u, 2 12" Sony Xplod subs w/ a 300W Kenwood. I already have a Pioneer GM-4300F amp basically a 40x4. Im looking at Components and I think i wanna go with the Eclipse...
Top