Recent content by beech2000

  1. B

    Looking to buy ear piercing marine 6 1/2s with a 2 channel amp for party cove

    Have you had a chance to price out your stuff? Any pictures?
  2. B

    Looking to buy ear piercing marine 6 1/2s with a 2 channel amp for party cove

    Never heard of wetsounds.Two recommendations now have my curiosity up. Thanks all!
  3. B

    Looking to buy ear piercing marine 6 1/2s with a 2 channel amp for party cove

    What are you looking at getting for the amps and speakers? I was looking for new recommendations but open if equipment is pristine.
  4. B

    Looking to buy ear piercing marine 6 1/2s with a 2 channel amp for party cove

    Would love to be able to install horns but where? Any amp recommendations?
  5. B

    Looking to buy ear piercing marine 6 1/2s with a 2 channel amp for party cove

    Sound? Have you heard them in another boat? Paypal?
  6. B

    Looking to buy ear piercing marine 6 1/2s with a 2 channel amp for party cove

    Have a small Sea Ray 190BR that we use on the lake sometimes to party during swim season. Currently a Street Edge 100 watt 2 channel amp with a pair of 6" components are installed. The Sub is 12" CVR in a small box behind an Alpine MRP-M500 mono block amp wired at 2 ohms. The problem is the...
  7. B

    Attempting to set gains with DMM, but can't reach desired voltage...

    Same here. Not sure what's the deal. Click the following http://www.caraudio.com/forums/amplifiers/596396-matching-head-unit-alpine-mrp-m500-using-fluke-dvm.html Good luck.
  8. B

    Matching head unit to Alpine MRP-M500 using Fluke DVM

    With bass boost all the way down I am only getting 2 VAC. something is wrong with this Alpine. I also tried using different RCA cable and same thing. I might be sending this amp in for repair.
  9. B

    Matching head unit to Alpine MRP-M500 using Fluke DVM

    Okay great I'll do that and recheck. I know my meter is fine as I used two others and same results. Thanks
  10. B

    Matching head unit to Alpine MRP-M500 using Fluke DVM

    Okay so decided to use my Alpine MRP-M500 in the boat and I need some help setting it up. I understand with my head unit at 75% volume my 12" sub wired at 2 ohms. I understand I should have around 31.62 VAC when checked with speaker disconnected and continuous 50htz tone. 500 watts RMS X 2ohms...
  11. B

    Newbie with a question

    Haven't seen any smoke and only turned it up for seconds at a time for sound experimenting so i can't imagine any damage to any of the components to date but sure glad for internet forums like this one. So as it stands, I have the KW in my truck wired with both vc's in series to give me a...
  12. B

    Newbie with a question

    I'll save up some money and go with Babykinns recommendation and get 1000RMS amp. I guess I have to high requirements or to high of expectations at a low budget. Bigger box is needed in any event. Humbling experience here for sure.
  13. B

    Newbie with a question

    And don't want to do that so now the Single Sub with both CVR vc's in series with measured resistance of 8 ohms. Sounds great so I am okay with the KW at this setting. Now for the boat.
  14. B

    Newbie with a question

    I am suspecting the amp itself as being bad but to much time has gone by to take it back to bestbuy troubleshooting. Its 6 months old.
Top