Recent content by Badcompany1995

I lack knowledge in the audio department but I have definitely had my patience tested over the past two weeks with this. It's like an emotional rollercoaster. When it comes on its like Christmas. When is shuts off its like the world just ended Sent from my HTC6500LVW using Tapatalk

Thanks

Thanks I appreciate the help Sent from my HTC6500LVW using Tapatalk

On the enclosure I took out the connectors and just ran the wires through the box straight to the sub. But if my remote wire is loose or disconnected the power light wouldn't come on from the amp right? I might take my hu out and make sure everything is the way it should be but I don't think the...

Those seem to be intact with no movement when I checked them. So do you think it would be the amp or the sub having the problem? Sent from my HTC6500LVW using Tapatalk

Thank you, this is getting frustrating because I can't figure out the problem. I hope I can figure it out

I've tried that. I don't know what I'm looking for though lol. And I've checked several times to see if the amp is hot but I don't feel any heat at all Sent from my HTC6500LVW using Tapatalk

No problem. How do I check resistance? And it powers up fine just no audio

I tried to go back to just using one channel bit still no bass. And I haven't seen my amp go in protection at all. It's driving me crazy because I have pretty much rewired everything. I've had this same setup for 3 or 4 years and never a problem until I bridged it a few weeks ago

Yes it is

I have checked all connections inside the enclosure and at the amp. Ground and power wires included. The sub does sound a little distorted. Sounds like static Sent from my HTC6500LVW using Tapatalk

So I have a JL 10" W0V2 sub and a JL 360.2 amp. A few weeks back I finally bridged the amp and about a week went by and my sub quit working. And then out of nowhere it would come back on but not for long. It got to the point that if I shook the enclosure that the sub would come on for a few...

It worked for about 30 seconds and still no bass. Even after I just went back to one channel Sent from my HTC6500LVW using Tapatalk

I'll let you know when I can get to the model number tomorrow but I'm gonna say it's 4. There was a wire that was detached when I took the sub out the box but I replaced that and just ran the wires from the amp straight to the sub instead of connecting to the box

So I'm not an expert by any means when it comes to audio installation but I can get it up and working. So the other day one of my buddy's wanted to see the setup in my truck so after he took a look at my humble system he proceded to tell me that if I bridge the amp I would get a little more bass...