Recent content by Babbar Khalsa

Thanks for the reply. Just looked up the speakers set. Should sound good for what am doing lol and not bad of a price. What amplifier would you go about using for these speakers to get the best out of them?

Hey guys I need your recommendations and advice on a new speaker upgrade I want to do in my 03 tacoma extended cab.I am planning on installing 6.5 component speakers. My budget is $550 for both front and rear speakers. I do plan on adding a sub later on, my headunit choice will most likely be a...

What does the wire from the alt to fuse box/battery carry? Amps or voltage? THANKS

Thanks bro really appreciate it

Ok so 250A fuse should be connecting to what? Alt to fuse block?

Hey everyone i am new, doing a big setup with a 250 amp alt and 2 yellow top batteries powering 2 audio q 2200 amps. I wanted to know how big of a fuse do i need. I want to be able to power all my equipment with sufficient power and not fry it or over load it. My trucks electrical system goes...

Ok i see, and is there a negative post or something like that because on my battery terminal i see a negative wire connect from the alt, how do i upgrade this? And going along with that there is a fuse wire (from the fuse box) going to my battery. Will the h/o alt and new battery harm the...

Ok i see. But on this positive post a wiring ring is needed for the 0 gauge wire right? And over this positive post that is on the alt is it going to be covered by the original rubber boot?

Its a 03 2.7l toyota tacoma. I get what ur sayin bro. But when the 4 gauge wire is being connected where is the battery terminal taking place?

i was planning on getting a high output alternator from a company but dont really understand the concept of wiring. Like idk how big the upgrade wire should be that is connecting from my pos term on alt and where/ how it is sopposed to lead to the battery and what other wiring is needed to take...

Hey guys i am not experienced with alternators at all and know nothing about them i.e. I dont know what wires are connected to the alternator and where they go to or how they work and what can u do to upgrade alternators to high output alternators and get all the wiring correct ? Some knowledge...