Recent content by arty

PPI's are only 60rms per side and image dynamics are very hard to find i found them on a couple of sites but with shipping costs about $200(i live in Greece) any other suggestion?

these looks really nice. what do you think about soundstream?

nice, any other suggestions?

which one do you thing will play best i have a kicker amp powering 120rms@4ohms per channel

hello again guys, i've decided to change my front door speakers and i was thinking to buy soundstream either reference or tarantula series for 6.5" which one do you thing is better, and do you have anything else to suggest within this price range? (i found tarantula $150 and reference $190...

had same problem, run same wire for both power and ground found a better ground also, is your power cable connected directly to the battery?

i know how to setup the amplifier correctly i just don't want blow up the sub i mean, is there any possibility that gain is set right, and the amp is currently producing watts that the sub can handle and still blow the sub?

ummm any suggestions?

what do you mean by that? i mean, what is "dirty power" it may blow the sub even if it outputs watts that the sub can handle?

i think this made me a little a bit happy cause i have a problem with the volume knob :P

when i start the vehicle i hear noise that probably comes from the engine the noise is there even when the RCA's are disconnected from the amplifier it's a small amp 2x35rms on a 8 guage cable

my HU has 5V pre-amp so the gains will be set to 0 i will build the sealed box that JL suggests i got this amp because i want to get a 2nd sub in the future but i don't want to blow this one until then any suggestions?

hey guys i just bought a JL 12w6v2 and a Kenwood KAC-9104D you think there might be a problem with this setup? the amp pushes 900rms at 2 ohms and the bass takes up to 600 is there any way to reduce the amp's output to match it with the sub?

i agree with Louisiana i think it's a ground issue

why do you bridge a 4 channel amp to run 4 speakers? crossover are built to "cut frequencies" and nothing more they cut high frequencies from midrange speakers and low frequencies from tweeters also, what;s the status of your amplifier when the sound goes off is the amp still running or is...