Recent content by apzoutes

wire all your positive together then all the negatives there's a pic on here http://mobile.jlaudio.com/support_pages.php?page_id=161

you can also wire them to .33 ohms and 12 ohms but most practical is either 1.3 or 3

I don't know anything about the amp except the specs you listed. It will slightly underdrive the speakers but as long as you properly set your gains you will be fine...ohms law voltage = the square root of watts x ohms...so 125w x 4 ohms = 500 the square root of 500 = 22.4 volts per channel

how much ar eyou looking to spend?

no it doesn't looked mixxed up...having a bigger box tuned lower will have better sq by having a flatter extended bass shelf and having a smaller box tuned higher will be louder and have a higher peak causing more of a 'boom' box response

yes, but remember a h/u may say it pusts out 2 volts but may be overrated and by the time the signal travels down the interconnects it will be lower at the amp

Diamond Audio D310D2

What amp?

I'm not on aim....If your selling I may be interested but it would be later in the winter.

LOL that is what I originally meant a 2500.1 per sub @ 1.4 the other three choice I was thinking of are one RFT40001 or Soundstream xxx 6500 or Digital Designs Z1 all would run @ .7 to both subs

that is what I meant originally when I was talking about two 1500.1 or two 2500.1...it would be one per sub

would I be better off running two 1500.1 @ 1.4

yeah, the dual 3 ohm is only on the 10"

even with imp rise wouldn't a .7 load Daily be too hard on a 2500.1

the show the dual 3 ohm only for the 10"