Recent content by apdetective437

Is it ok to ground the CAP into the ground block where i have my 2 amps grounded to, or should i give it its own chasis ground? Any help will be greatly appreicated. Thank you.

doing an install on 04 mazda 6. having trouble figuring out where to run the speaker wire to the doors. The rubber boot in between the rear doors has a big plastic plug which is the entire size of the boot....and on the other side of the boot going into the door, there is a big solid plastic...

Doing an install on my sisters 04 mazda 6. having trouble with steering wheel control adapter -SWI Jack. where do i need to hook up the white (interface wire)? Also program function not working properly.

audiohbahnuser18 - I mean for a starting battery... Im having a problem right now and i think it might be the battery. i dont think the amp for my subs is getting all the power it needs. The problem - after playing my music at volume 20 or higher for about 5 minutes, my amp for my subs will...

does anybody know where i could get a high output alternator for a 98 chevy lumina? any help is appreciated

Im thinking about upgrading to an Optima battery. But, will it make a difference? is it worth the money?

thank you

properly tuning amps is my weakness. when setting the frequency level....obviously setting it according to the frequency output of the speakers is the right thing to do...but how do u do that? is the number u put it on is that the lowest frequencies it will put out and every thing bove that...

oh, i forgot to mention i also have my 2 farad cap grounded into the ground block. should i give the cap a chasis ground instead of grounding it in the block?

yes thats what happens it overheat a little bit... im not sure if its the gain

-------------------------------------------------------------------------------- I have a kenwood kac 9103d mono amp putting out 900w rms- and 2 dual 2 ohm 12" type r's. I have 0/1 gauge kicker wire which goes into the distro blocks and 4 gauge going to the amps. also have an alpine mrp f250...

I am having the same problem... I have a kenwood kac 9103d mono amp putting out 900w rms- and 2 dual 2 ohm 12" type r's. I have 0/1 gauge kicker wire which goes into the distro blocks and 4 gauge going to the amps. also have an alpine mrp f250 .but don't have a problem with it just the amp for...