Recent content by another1

Ok, hoping for some legit experience. I'm building an enclosure for 4 12 inch Type Rs in my trunk. I can't make up my mind on what type of port to use.. Can/ will build anything except for a wall, I'm regularly 4 deep and with my seats up it, we'll its terrible.. Most likely firing backwards...

I have an Alpine M240 amp... 1500 watts at 4 ohms and 2500 at 2 ohms... and 3 10 inch type r's all dual 2 ohmers... right now im running them at 3 ohms, and they are doall in individual .85 cuft sealed chambers... They do sound good... But.. I miss my ported bumps.. Here is my dillemma ...

Just ordered 3 10" Type r's... they will be powered by a Rockford 1500watt amp.... aprox 1500 watts rms @ 1.3 or 2.6 ohms between the 3... All our local shops are booked too far out for my patience to make a box and most boxes i have found online so far look cheaply made... box is in my...

ok will do

To be exact, I have a buddy that would swap amps..

OK, thanx for all of that.. one more question.. I have immediate access to an Audiobahn A2200HCJ which is capable of running 1000W x 1 @ 2 Ohm Mono... Yes or no?

OK, which would bring me to my next question.. will just replacing the amp fix that or do I want to start all over... I like to feel my bass more then just hear it.. i have a big four door and it takes a bit to reach up to the front.. Of coarse I still want sound quality which is why I went with...

my bad... I am getting alot of distortion.. my trunk is pretty well dynamatted. and it just sounds terrible, it is also clipping..

OK Guys like usual I am hoping for some experience.. I have been been building my own stereos for 10+ years and the fact that I can not figure this one out is driving me mad! I have a JL 10w7 in a ported box (that is to exact JL specs) and it is powered by the recommended jl 500 watt amp...