Recent content by angler02

  1. A

    Amp selection for 2-12w6v2 JL audio subs

    I was looking at a stinger spp680 but i worry its not enough for 1300 watts. The company site says it is. I see other sites saying onky up to 800 watts.
  2. A

    Amp selection for 2-12w6v2 JL audio subs

    Any reccomendations on batteries? Its a 2013 civix si, so far I'm looking at a yellow top optima 51r. I have the 1200.1 on order as well.
  3. A

    Amp selection for 2-12w6v2 JL audio subs

    Thank you very much for the link.
  4. A

    Amp selection for 2-12w6v2 JL audio subs

    Ok so i wired them at 2ohms and it went straight into what i assume is protect mode for this amp. So thats out.
  5. A

    Amp selection for 2-12w6v2 JL audio subs

    Ive seen a lot of mixed reviews and opinions on going ported with this particular sub. Im not opposed but i have kids etc now so the smaller box in the trunk was the idea behind one sub for vs two. Sounds like i shoukd have gone with the w7 lol.
  6. A

    Amp selection for 2-12w6v2 JL audio subs

    I have the jx series im sorry for not specifying. Ive looked at the hd 750/1 because that would throw 375 watts to each sub at 4ohms. Or i guess it would all the way down to 1 ohm. So at this point my next step is to run these subs on the x1200m amp at 1ohm and see what that does. If im unhappy...
  7. A

    Amp selection for 2-12w6v2 JL audio subs

    The slash actually does 500 rms at 2ohms and 340 rms at 4 ohms. The slash actually puts out 500 rms at 2ohms and 340 rms at 4ohms. Per jl specs.
  8. A

    Amp selection for 2-12w6v2 JL audio subs

    Each 12w6v2 is in a sealed box to jl spec. 1.3 cubic ft.
  9. A

    Amp selection for 2-12w6v2 JL audio subs

    Oh im here for help. I have a basic understanding and have done hours of reading going through forums watching videos etc. JL reccommends that you set all amp levels to lowest setting and run a 50 hz tone and adjust up until you hear clipping then back it down. So i havent had it set on any...
  10. A

    Amp selection for 2-12w6v2 JL audio subs

    This was a thought i had as well. I was concerned about the amp but at this point i may as well try it and see what happens. It doesnt tell me the wattage rms at 1ohm it just says stable down to 1 ohm which was why i didnt go that route just yet.
  11. A

    Amp selection for 2-12w6v2 JL audio subs

    I want to lay out the full story here so its understood the process Ive been through to get here. I started about a year ago when I purchased one used 12w6v2 to replace the basswedge i have with 2- 12w0v3. Upon receiving the new sub i hooked it up to my 500/1 jl amp and it blew. I got my money...
Top