Recent content by AngieD700

So, this is the amp I had from years ago. Not sure how to test if it’s still good. Also, would this be enough to power my front and rear speakers? Sent from my iPhone using Tapatalk

So, installed one side today...no time for the other side. Went the route you suggested. I just couldn’t tap into speaker wires for the input on the crossover. Just used the OEM plug from door and ran wires through boot to crossover, which I mounted behind kick-panel. Only issue, can’t get that...

Here is a link to a vid that pretty much explains those settings. There is a time alignment too. So I’m not sure if I should set my external crossover to 0db and then make adjustment through HU. Sent from my iPhone using Tapatalk

Ok...this all makes sense...I already did the rear speakers. Used some speaker and speaker wire adapters and they all fit fine. The boot part on the front doors is what worries me...but I’ll see what I can do. This setup will be good bc then I can make adjustments on the crossover from the...

Also, my pioneer HU has these “Speaker Level” adjustments that is to address any axis requirements...again, I understand that very little. Not to sound stupid, but do you address off/on axis with actual tweeter placement or, place both the same spot (of across one on left one on right), then...

Ok...good to know about the crossover and not to install inside door panel. In that case, I’m not certain how to run the wires into the car. This would be the woofer and tweeter speaker wires that are connected to the crossover, as well as the wire from the plug that originally plugged into the...

I’m driving a Mazda 6. I will def check my older equipment. If anything use that till I shop around. Thanks Sent from my iPhone using Tapatalk

Lol...no worries...I’m all intrigued now...have to see how it all plays out [emoji6] Sent from my iPhone using Tapatalk

Hey guys...thanks for the welcomes So, I have a 15 Mazda 6 Sport. I’ve already installed a Pioneer 4200. Based on the advice from Crutchfield, I got Polk db6501 components and Polk db651s for the rear door speakers. I don’t know where these land on the quality scale. I see some of the...

Ah yes, I-Drive and Kirkman...in the middle of all the attractions Well, at this point, i literally just decided that I may start working on having a decent system. Before, I was fortunate that had a cousin who installed everything for me and gave me all my equipment (speakers, subs...

So...many years ago, I was “that girl” who had the killer system...worth more than my little Mazda 323. Anyways, fast forward, I got an aftermarket head unit...and it was supposed to end there. Then, it didn’t end there, and I decided a cheap pair of speakers couldn’t hurt...and, let’s face it...