Recent content by acreature

87 on site 639 on FB

Size 10 -inch Impedance 2 ohms Cone Material Textured copolymer Surround Material NBR Ideal Sealed Box Volume (cubic feet) 0.75 Ideal Ported Box Volume (cubic feet) 1 Port diameter (inches) 3 Port length (inches) 11 Free-Air No Dual Voice Coil Yes Sensitivity 84.9 dB at 1...

Amp Integration Interface. AOEM-FRD24 Works perfectly for adding my sub.

In the trunk Vid: Don't mind the crap phone mic. She don't sound like that.

Anyone who has had a box wrapped in Vinyl; what was the cost? This box is approx 12x18x15

It's getting there

Question... with the aero port, I can mount that on the outside, correct? With it being 16+ inches in length... could that be placed through (flush) the rear deck, or would that be a waste with the sub in the trunk?

Creature of habit. I like the looks of a slot over a round. I will try the aero port next, though.

Reworked the design a bit so I wouldn't have to load the box with scrap to get it down to 1 cu ft. Will be finished tomorrow. Appreciate the critiques.

Agreed.

Just for shitz-n-gigglz, what if I wanted a dual slot port for the 1cu. (Just for the look) A slot on left and right sides of the woofer. Is there a way to figure that with no more or less than a 1.5" x 10.5" slot dimension for each port? Or would the ports be so long as to make the enclosure...

No one can make this easy for an occasional hobbyist, ha!

I will. I will build the slot vent first, then play with other ideas.... including the aero and passive radiator. Here is where I am with the 1.5" port width It is 35.25" port length. I am going to have to block the inside a bit to get the cubes back down to 1.

My have to play with that idea. On a one month staycation, so I will be wasting a lot of time in the tool shed.

Aiight. Appreciate the patience and advice.