Recent content by 6 SPEED

I've got an Alpine MRP-M1000. Works, I just dont have the end caps/covers. Specs listed here: Alpine Electronics of America, Inc. Would do 200 shipped.

Buddy of mine has a 94 Saab 900, I agree. It's really quiet on the inside, very little road noise. For stock speakers it sounded really clear and very present. Granted the speakers ****** hard at any decent volumes with the aftermarket radio, but for stock I was pretty surprised.

Port at the bottom would run into the sub. Also trying not to move the amps upwards, because then they start to get visible through the back window. I guess I should mention that stealth is a little bit of a goal here. The sub will have a dark grill over it to minimize visibility from the front...

Ok, a buddy of mine spent some time helping me learn Sketchup, so I was able to finish the model of the box. Box is modeled with the Kicker CVR 12" I have now (which has similar ported box specs to the Sundown SA-12 that I want later), the Alpine MRP-M1000 I have, and the Alpine MRP-F300 I plan...

I've got a question I've not yet found the answer to on here, though I am still looking. If this has been covered before, I do apologize. I drive a 98 Ford Ranger single cab, and anyone that know's these little trucks knows these things have about as much room as a bodybag. I'm planning on...

Audiobaun, I went out and measured my truck, and plugged the available space into the box calc that RE offers on their website. How does this look to you?

Thanks Audiobaun! I need to measure the full amount of space I can utilize, but I should be able to do somewhere in the neighborhood of 2cf. I was looking up the sub, and the specs I found called for 1.75 minimum for a ported box. Are there any problems to be had with running the smaller size...

Also, budget right now is downright non-existant. Truck suddenly decided it needed things fixed, so I wont even have the cash to pick up lumber for the box for a week or two. Definitely need to see what I can do with what I have lol

I got the Alpine and Kicker as part of a trade, they're sitting on my desk right now. The Alpine definitely works, I flat out toasted the Sony sub I had in there as a temp. The truck is currently wired up with 4g wire, power and ground, with the ground bolted to the frame right below the cab. I...

Thanks for the advice on the Kicker. What do you say about the SD2-12D2 on this amp, wired for 4ohm? I've got to pull the rear trim out of the truck and measure out exactly how much space I've got, but I should be able to fit the 12 with the box I want to build. Going into a single cab Ranger...

Picked up a Kicker 05CVR122 (12" dvc 20hm) and an Alpine MRP-M1000 in trade yesterday. I know a lot of people on here hate on Kicker, but it wasn't something I dropped money on. I've heard it both ways that the Kicker will take more power than it's rated for, and that it'll take a dump with...