Recent content by 3onthree

since it wouldnt let me post in my first topic i had to start a new one. my ports are made of abs and i used duct tape to hold most of it together but on one spot i have to use some kind of adhesive. whats the best thing to use for abs? plastic weld? Permatex 84115 PermaPoxy 5 Minute Plastic...

trying to wire up my pair of dual 4 ohm sa8's to one ohm on a sax1200d amp. im following this diagram but im trying to stuff two 12ga wires into some of the posts and it doesnt fit. should i cut some of the strands of wire off or use 16ga wire? also the amp is monoblock but has output terminals...

thanks ordering them now

i thought it would be better not to go all the way through the baffle but if you think it would be better to get longer ones ill get the 1''

will these screws work good or are there better options?#8 x 3/4" Deep Thread Pan Head Screws Black 100 Pcs.

thanks guys

i have a lot of pieces to my aeroport (dayton 4'' port pieced together from parts express). i have outer flare, inner flare, elbow, coupler, and two straight pipes all dayton and they are made of abs. should i use some kind of glue or cement to keep all the pieces together or will duct tape...

pm sent. do you have any d4s left?

**** that ***** guess ill have to wait a couple months then

im going to try to make my first set of fiberglass kick panels but am not sure if i can do this in winter temperatures in a non heated garage. will i be able to do this in 10-30 degree outside temps (a little warmer in garage) or do i have to wait till it warms up? im worried about the resin not...

what are the outside dimensions of that box?

i dont have any speaker wire yet but im gonna order some from knu just dont know what to get yet. is quality speaker wire not that important for mids and highs?

what gauge speaker wire did you use going from amp to crossover and crossover to tweeter/midrange? i was thinking 12ga from the amp to the crossover and 16ga to the tweeter and mid? components are ID CTX65CS and amp is sundown sax125.2

mount by the amp (in the trunk) or by the comp speaker (in the kick panel area). obviously im gonna need more wire if i mount them by the amp since one wire goes in and two come out so id prefer to mount them by the speakers is one way better than the other?

they didnt charge me to cut at lowes either