Recent content by 09VIC

The only issue is no one with electrical knowledge seems to be chiming in.

Just want to say you guys are like encyclopedias...

Yeah my man that's what I'm doin here...

I seen that Idea but I'd rather not do that it keeps voltage that low for a reason I don't want 14.4 constant just when I need it.

Yes that is correct my PCM sets the voltage to charge at that. Is there a way to manipulate the alternators wiring to make it do 14.4?

I believe they are mitsubishi 200 amp alternators.

No I have a stock 200 amp alt that is putting out 13.5-13.8 volts. I want to somehow have a dash switch wired to my alternator that could switch it from 13.8 (regulated by the pcm) and 14.4 (internally regulated). I need to know if this is even possible with an alternator.

I have done the big three and I have a 1/0 charging cable from the alternator fused at 250 amps. My alternators voltage is controlled by the PCM but in reading about adding a second alt you twist two of the wires together and run them to a switch when you need the voltage so I figured there...

Hey guys my sound system would like to take advantage of my 09 cvpi's 200 amp alternator but I read somewhere the vics are regulated to charge at around 13.5. Is there a way to bump it up to 14.4? Can I somehow wire the alt to a switch that could make it internally regulated instead of external...

My gain is at 12 o'clock and my box is the q bomb spl one ( I know I built my own but when I cut the holes for the subs to website specs they were way too big so I just settled for now) my head unit is a pioneer avh-3300bt and my rcas are the ones that came with the belva kit(on the surface...

If I were to clean up my install a bit? I just upgraded my sub amp and it seems like I should be feeling the bass a little more after roughly tripling my RMS. When I got it today off course I ripped my old amp out and installed the new one but I did get kinda shi*** on the install though it's...

I want them to get cleaner power which I assume they would at 2 ohms. If they are slightly out of phase with each other can it damage my subs?

I currently have an ssl 5000d hooked up to two dvc4 alpine type R's at 1 ohm. I have been made aware that amp can't cleanly supply my subs with enough power so I plan to either purchase a cab 1600 or an audiopipe 1800 to replace it. In the meantime until I get the money I have a belva bb2000 amp...

Ok and next question if I were to get another amp the audiopipe 1800 seems like a good way to go and until then to save my subs would it be possible to run them at 2 ohms off of my two different amplifiers if they are gain matched? The other amp is a belva bb2000 and whole no true numbers exist...

Guys after unplugging the remote I was able to get my desired voltage with just the gain adjustment. My new problem is even though I went under the voltage I could and tuned it to 34 after driving around for about 10 minutes with the radio at 30 out of 40 went I popped the trunk I smelled the...