Tim Burdeshaw
CarAudio.com Newbie
- 2
Hope someone can help with my new install? I am on a tight budget and I know that two pair of the current speakers are crap and will be replaced later. So far I have $125 invested.
Components :
Pioneer MVH-S600BS
Alpine MVR-F352
Speakers:
VR3 6X9s 3 ways 100 watt
Emerson 4 " 2 ways 70 watt (LOL! I know.)
Planet Audio 12" Dual voice coil 4 ohms 1800 watt Peak. RMS unknown? In a box I built to manufacturers specs
I am having problems getting everything tuned to where it sounds decent at volume. I have a crossover in the stereo and the crossover on the amp. I was told to use only one of them and not both.because of phase distortion. I wired the sub parallel @ 2 ohms. I amp using the amp to run the 2 6x9s and sub in a 3 channel configuration and the 4s in the dash are running off the head unit. My phone has an EQ. My stereo has an EQ. Which one do I use and what do I set the other at? Same for the crossovers? Any advice would be greatly appreciated!
Components :
Pioneer MVH-S600BS
Alpine MVR-F352
Speakers:
VR3 6X9s 3 ways 100 watt
Emerson 4 " 2 ways 70 watt (LOL! I know.)
Planet Audio 12" Dual voice coil 4 ohms 1800 watt Peak. RMS unknown? In a box I built to manufacturers specs
I am having problems getting everything tuned to where it sounds decent at volume. I have a crossover in the stereo and the crossover on the amp. I was told to use only one of them and not both.because of phase distortion. I wired the sub parallel @ 2 ohms. I amp using the amp to run the 2 6x9s and sub in a 3 channel configuration and the 4s in the dash are running off the head unit. My phone has an EQ. My stereo has an EQ. Which one do I use and what do I set the other at? Same for the crossovers? Any advice would be greatly appreciated!
Last edited by a moderator: