Fi-brations 10+ year member
CarAudio.com Elite
Last edited by a moderator:
Good 3k Amp
- Thread starter Fi-brations
- Start date
- Replies 14
- Views 1K
-
- Tags
- wtb
-
9Participant count
-
Participant list
Fi-brations
Vertex Audio Pro Seller
Supporting Vendor
What is your budget?
Jeffdachef 5,000+ posts
Gunz That Turn on Nunz
OP
Fi-brations 10+ year member
CarAudio.com Elite
- Thread Starter
- #4
Looking for used, under $700
No thanks.
mylows10 5,000+ posts
B2,singer,ampere rep
Vfl 150.1 ?
NASTY08IMPALA 5,000+ posts
CarAudio.com Veteran
Ive only seen 1 vfl150.1 do over 3k and it was wired at .5 and rose to .9..not a bad amp but not in my list when u can find any korean board aq dd ampere dc saz bc3500 etc etc all the time for 5-600 bucks
OP
Fi-brations 10+ year member
CarAudio.com Elite
- Thread Starter
- #7
no thanks
NASTY08IMPALA 5,000+ posts
CarAudio.com Veteran
Those skar amps are very good amps especially the 3500 and 4500 ..id snag it in a heartbeat
OP
Fi-brations 10+ year member
CarAudio.com Elite
- Thread Starter
- #9
Thanks for the tip, I honestly didn't know if it was good or bad, but i just dont want to run skar...
Jeffdachef 5,000+ posts
Gunz That Turn on Nunz
Eggroll
RingsOfSaturn>your music
**** that thing was a steal a few days ago... //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif Still kinda is for a 5k
SounDrive Pro Seller
www.soundrive.audio
I'm selling two Taramp's DSP3k 1 ohm versions. They've been installed for less than a month and are in pristine condition. These are the newest Taramps and are much more sturdy. They have an onboard voltmeter, clip indicator, flat response down to 8hz, a clipping limiter (set it to 1% or 10% THD depending on your tastes, turns the amp down instead of clipping!), lots of crossover options, and tons more features and improvements. They're also a lot smaller than a Korean 3k.
I'm asking $450 shipped each. They still have over 10 months left on the warranty. I'm only selling them to upgrade to a larger amp, probably a HD10k
I'm asking $450 shipped each. They still have over 10 months left on the warranty. I'm only selling them to upgrade to a larger amp, probably a HD10k
Crownvicon28s 10+ year member
God 1st
I have a CT 4000.1 solid 5k+ amp. 600 shipped.
OP
Fi-brations 10+ year member
CarAudio.com Elite
- Thread Starter
- #14
Pmd
Activity
No one is currently typing a reply...
Similar threads
Mine were as short as possible and still I had issues routing them cleanly
- Started by kanihoncho
- Wiring, Electrical & Installation
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
The umm1 is just a rebadged dayton/minidsp mic.
I personally have a umik2 and use a regular usbc-usbc to hook it up to my laptop and a...
- Started by JoeMama541
- Amplifiers
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
- Started by kanihoncho
- Speakers
Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
- Started by kanihoncho
- Speakers
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 14
- Views
- 1,072
- Last reply date
- Last reply from
- rfluvinmf
Latest topics
-
-
-
-
-
Cost of amp power install kits vs individual products
- Started by kanihoncho
- Replies: 3