destined2race 10+ year member
Already Being Used....
Last edited by a moderator:
Solo X Advice
- Thread starter destined2race
- Start date
- Replies 6
- Views 902
-
4Participant count
-
Participant list
-
destined2race
Popwarhomie 5,000+ posts
Team Lethal Pressure
Well a 2500rms subwoofer on 800rms could be the cause.
OP
destined2race 10+ year member
Already Being Used....
- Thread Starter
- #3
Yeah if I keep it ill probably end up throwing my AQ2200 on it, more so I wanted ideas on enclosures people have had with them.
adulbrich 5,000+ posts
Olive oil un-virginer
If all you really want is lows, go ported
OP
destined2race 10+ year member
Already Being Used....
- Thread Starter
- #6
It is ported and it doesn't hit the lows in a pretty large box... I put that in my original post. And if its just because of low power than ill have to test it out on the other amp
adulbrich 5,000+ posts
Olive oil un-virginer
Sorry, I missed that bit. It might be the low power, but like you said, Solo X's are not exactly known for their low end.
Activity
No one is currently typing a reply...
Similar threads
- Locked
Clearing out storage. $75 + shipping. Located in Carlsbad, CA. Pick up OK. Shipping weight is probably around 13 pounds. Slightly to deep to...
- Started by SnoringDad
- Car Audio Classifieds
Watch the video pop put up. Those don't put up anywhere near what they claim. Hence why spokey said run it at 1 ohm.
- Started by Bob Ross
- Wiring, Electrical & Installation
I wouldnt think so.only way to find out is trial and error
- Started by Blackout67
- Enclosure Design & Construction
Signal flow should be HU to DSP to amps. You would lose the ability to EQ and time align the sub with the DSP unit if you bypassed the DSP.
- Started by supafly1
- General Car Audio
Lowering the impedance will also lower the speakers motor control, or damping, in physics no free lunch exists.
It’s all give and take.
- Started by Paul Curtis
- General Car Audio
