Help!! My 1000 watt Kenwood amp keeps blowing the 40a fuse.
- Thread starter OgStickeyBuds1
- Start date
- Replies 8
- Views 5K
bad ground, too small power and/or ground wire, improper ohm load on amp, improper gain settings.
Falcons 5,000+ posts
that **** i dont like
Dude you installed it wrong. That's why.
- Thread Starter
- #6
It didn't do that before. I use to be able to turn up all the way. It just recently started doing that.
Falcons 5,000+ posts
that **** i dont like
Give us the 411 on the install
robertoyoung08 10+ year member
CarAudio.com Elite
if you havnt changed any settings or anything. then check the wiring. maybe ground got lose.
gckless 5,000+ posts
CarAudio.com Veteran
Something changed. You need to find out what. Probably the wiring, look for a short somewhere.
Activity
No one is currently typing a reply...
Similar threads
Read up on this first.
https://www.bestcaraudio.com/car-audio-myths-you-cant-ground-a-car-audio-amplifier-to-the-battery/
Then watch this on amp...
- Started by Joe Shmo
- General Car Audio
Honestly I don't think it would be hard for them to make it where you use android auto AND your own music source. They made it able to do so...
- Started by fadetoblack73
- Head Units
Agreed with this here. Since you have the unit pulled out of the car/dash...test it at your car battery directly for operation. very simple to do...
- Started by genasis coupe 3.8
- Wiring, Electrical & Installation
This may be an option for you as well. Im sure Amazon has them on theyre site also to be purchased. Great amps...
- Started by Chris Gerrish
- Amplifiers
Yeah, put the probes on the power wire and ground wire of the amplifier. Multimeter on DC.
Do not put it on the wires that go to your speakers. M
- Started by Mr FaceCaser
- Amplifiers
About this thread
Latest topics
-
-
-
-
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1