Reply to thread

Message: <blockquote data-quote="BassAddictJ" data-source="post: 3991310" data-attributes="member: 560415">you will need to upgrade that 4awg piece from back bat to amp up to 1/0 soon as possible. get the big 3 done too asap. only other upgrade from there would be doing a dedicated negative run of 1/0, which eliminates the need for the big 3. also what kind of battery up front? if the amp is only 2 ft away from the back battery that helps. haveing a 180amp alty helps alot too man.i've ran my kx 2500.1 at 1 ohm off a red top up front, and a g31 red top in the back, volatge drop was to about 12v steady but it ran fine all day. keep an eye on your voltage, as long as you dont dip under 12v much you should be just fine. with that HO alty you shouldnt run into this problem unless you bump it full tilt with your rpm's low. if your rpms are up youll be set.</blockquote>

Top