Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Zv4 15 box almost done!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jeffro83" data-source="post: 8618953" data-attributes="member: 674133"><p>Spax screws are cool I've used them a few times but I would bet my bottom dollar they would split three quarter inch material with no pre-drilling and that other way seems like it's just way too much work but thanks for the tip though if it continues to be a problem in the future I might give it a try but I have never had two pieces of would not join together properly because of the screw sometimes they push apart when the screw starts cutting into the second piece of material but if you just keep cranking it will **** them both together tight as it could ever be</p></blockquote><p></p>
[QUOTE="Jeffro83, post: 8618953, member: 674133"] Spax screws are cool I've used them a few times but I would bet my bottom dollar they would split three quarter inch material with no pre-drilling and that other way seems like it's just way too much work but thanks for the tip though if it continues to be a problem in the future I might give it a try but I have never had two pieces of would not join together properly because of the screw sometimes they push apart when the screw starts cutting into the second piece of material but if you just keep cranking it will **** them both together tight as it could ever be [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Zv4 15 box almost done!!!
Top
Menu
Home
Refresh