Reply to thread

Message: <blockquote data-quote="aeronautica86" data-source="post: 1944034" data-attributes="member: 559427">I'm confused as to how this will work, can anyone explain a bit better how a mono amp uses 2 terminals to wire up subs as if it were two seperate channels?edit: let me clarify my question.  so there are two sets of speaker terminals on the amp, and I have two subs both single 4ohm VC, wired independently of each other.  If I take speaker wire from the + - of the 1st set of terminals on the amp to the first subwoofer, and the + - of the second set of terminals on the amp to the second subwoofer, this effectively represents a 2ohm load into a single channel to the amp, as if I were running two S4 subs in parallel?  So basically I can run my two subs in parallel and not have any wires running between the two subs?</blockquote>

Top