WTB: 1/0 awg 5 ft Power and 5ft Ground and Binding post

[Trancer 10+ year member]

Hey guys,

I need about 5 foot of each power and ground 1/0 awg cable.

Also need 8 speaker terminals to crimp to my wire and attach to my binding posts

Also since I am stepping up my wattage to each sub, I will check around my garage, but I will need probably about 10 ft each of power and ground of 8-10 gauge wiring for my subwoofers since each voice coil will be receiving roughly 500-750wrms. I believe I am right on my wiring size with that wattage, correct?

Also I need some binding posts. I need a pair. I will be wiring each 12 to a once channel each.

I found a set that someone was using. It looked like it was being used in an SPL competition, but I cannot seem to find it. It was one square binding post that had both the negative and positive binding post on one. If anyone can help pinpoint what Im talking about, that would be great.

I have searched on the internet for power cable by the foot AND binding posts, but neither of these sites have both. I'd rather buy from one place rather than two places to save on shipping costs.

I dont have much of a color preference, but would like the power and the ground to be distinguished. EI Power: Red, Blue, Green, etc... Ground: Black, Grey, etc... Or something. Just distinguished. If not, then I can make due

Click to read more...

 

[Trancer 10+ year member]

Oh, I guess it would help if I posted how large I need the binding post. They will be going to two LMS-R 12's running roughly 1000-1500 wrms on each. So I will need them to accept 8-10 gauge wiring.

 

[disturbed471985 5,000+ posts]

8-10awg speaker wire for 1500watts?? I mean it want hurt but its kinda overkill..

 

[Trancer 10+ year member]

Just going off of this from the the12volt.com

Recommended Power and Ground Cable Sizes & Speaker Wire Size and Length

Maybe Im wrong? 12ga should suffice like I have been using then?

Im sure I am probably wrong. I havent slept. Been up all night

 

[Below20hzonly 10+ year member]

how do u post a thread i cant figure it out ?

 

[Trancer 10+ year member]

Hope you are joking

Anyway, back on topic and ignoring his post