Reply to thread

Message

<blockquote data-quote="mjbarr3" data-source="post: 8705795" data-attributes="member: 679756">Hello , I hit on this site by accident and glad I did.I am an older guy , so I might not understand some of the terminology going on here so bear with me Please.I just purchased a new truck, and one of the first things I wanted to do was change the HU. I decided on a Kenwood DMX 760s because I&#039;ve had good luck with that brand. I&#039;m not totally new to car audio, but i&#039;ts been a while since I&#039;ve installed one , so I need some help.My truck has a factory BU camera and on the &#039;19s they changed to a 40 pin connector for the camera power and ground and signal. I&#039;ve searched and no one makes a harness that works with that except Metra , its a 40 pin harness for a car but the pins don&#039;t exactly match. I have narrowed down the 4 camera wires from the factory harness and their position in the connector, but I don&#039;t know how to repin a connector and then where to connect the other end of the repined harness . I hope someone will help or can point me to another post.O Yea, I also have a IData Maestro SW i need to add to the harness. Thanks</blockquote>

[QUOTE="mjbarr3, post: 8705795, member: 679756"] Hello , I hit on this site by accident and glad I did. I am an older guy , so I might not understand some of the terminology going on here so bear with me Please. I just purchased a new truck, and one of the first things I wanted to do was change the HU. I decided on a Kenwood DMX 760s because I've had good luck with that brand. I'm not totally new to car audio, but i'ts been a while since I've installed one , so I need some help. My truck has a factory BU camera and on the '19s they changed to a 40 pin connector for the camera power and ground and signal. I've searched and no one makes a harness that works with that except Metra , its a 40 pin harness for a car but the pins don't exactly match. I have narrowed down the 4 camera wires from the factory harness and their position in the connector, but I don't know how to repin a connector and then where to connect the other end of the repined harness . I hope someone will help or can point me to another post. O Yea, I also have a IData Maestro SW i need to add to the harness. Thanks [/QUOTE]

Verification