Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Wiring speakers from crossover
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="J0N8" data-source="post: 8895197" data-attributes="member: 693379"><p>As you can see regardless of the voltage or the ohms, this particular JL Slash amplifier is similar to the HD lineup of amplifiers they have currently have the same rips technology. </p><p></p><p>The speaker sounds fine. I noticed the difference if I tapped into the power output vs the woofer output Of the crossovers, then it sent full range signal to the center speaker . At first, I had put a coaxial 5 1/4 JL that I had from before but was too bright up front</p><p></p><p>I have the JL C3-6.5 inch components in the rear doors and a JLTW3 12 inch in a box specifically made for it from JL and I’m quite happy with it. </p><p></p><p>Thanks for the advice, my thoughts are if I were to try a different amp without the rips technology it may not work correctly.</p></blockquote><p></p>
[QUOTE="J0N8, post: 8895197, member: 693379"] As you can see regardless of the voltage or the ohms, this particular JL Slash amplifier is similar to the HD lineup of amplifiers they have currently have the same rips technology. The speaker sounds fine. I noticed the difference if I tapped into the power output vs the woofer output Of the crossovers, then it sent full range signal to the center speaker . At first, I had put a coaxial 5 1/4 JL that I had from before but was too bright up front I have the JL C3-6.5 inch components in the rear doors and a JLTW3 12 inch in a box specifically made for it from JL and I’m quite happy with it. Thanks for the advice, my thoughts are if I were to try a different amp without the rips technology it may not work correctly. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Wiring speakers from crossover
Top
Menu
What's new
Forum list
