Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Wiring help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="sickofsoyo" data-source="post: 3552859" data-attributes="member: 580630"><p>I am planning on putting 2 sets of JBL C608GTI component speakers powered by JBL PX600.2 Amps. The RMS on the speakers is 150 W @ 4 ohms, which these amps provide, with a Max of 600 watts. The amps provide 150 W @ 4 ohm into 2 channel RMS, with max power rating at 1200 Watts. My question is how am I going to wire this setup? I need a distribution block, but what guage wiring and what else? Do I need anything else to make this work? The car is a 2003 Monte Carlo SS.</p><p></p><p>Attached is a quickly drawn diagram of what Im looking for, so maybe if someone can copy it, and edit in what I need and where, it will help me more.</p><p></p><p>Yes I know the battery is further up than where I put it on the image</p></blockquote><p></p>
[QUOTE="sickofsoyo, post: 3552859, member: 580630"] I am planning on putting 2 sets of JBL C608GTI component speakers powered by JBL PX600.2 Amps. The RMS on the speakers is 150 W @ 4 ohms, which these amps provide, with a Max of 600 watts. The amps provide 150 W @ 4 ohm into 2 channel RMS, with max power rating at 1200 Watts. My question is how am I going to wire this setup? I need a distribution block, but what guage wiring and what else? Do I need anything else to make this work? The car is a 2003 Monte Carlo SS. Attached is a quickly drawn diagram of what Im looking for, so maybe if someone can copy it, and edit in what I need and where, it will help me more. Yes I know the battery is further up than where I put it on the image [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Wiring help
Top
Menu
What's new
Forum list
