Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Wiring harness and temote-run on install help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Heresy" data-source="post: 98495" data-attributes="member: 540683"><p>The wires that power the HU are a constant 12V line that keeps the clock set on time and saves your settings. A 12V accessory switch is run off the ignition to switch on everything when the key is set to either the accessory position or when the engine is running. There can also be an illumination wire going to the HU but it is not necessary.</p><p></p><p>All other wires are for speakers or to turn on amp(s). Remote turn-on means remotely turning on amps, not the actual HU in the dash.</p></blockquote><p></p>
[QUOTE="Heresy, post: 98495, member: 540683"] The wires that power the HU are a constant 12V line that keeps the clock set on time and saves your settings. A 12V accessory switch is run off the ignition to switch on everything when the key is set to either the accessory position or when the engine is running. There can also be an illumination wire going to the HU but it is not necessary. All other wires are for speakers or to turn on amp(s). Remote turn-on means remotely turning on amps, not the actual HU in the dash. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Wiring harness and temote-run on install help
Top
Menu
Home
Refresh