Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Wiring dual 2ohm spearks to two strapped amps?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="1aespinoza" data-source="post: 8709717" data-attributes="member: 654802"><p>That is alot of power, I mean like ALOT. You need some serious juice going to these kiddos! If you have that covered, you connect positive to positive then negative to negative on one sub. Then you connect that sub to one amp. Do the same with the other. Each sub will be 1ohm to it's own amp. Now connect rcas from radio to one amp in the input side. Then connect short rcas to the output side of that same amp. Finally, connect the other end of those short rcas to the input side of the other amp. You are done. Tune to your hearts content and bass on. You can also strap those amps but will need to gain match them. A tad bit on the complicated side. What is better than one bass knob? Two bass knobs!</p></blockquote><p></p>
[QUOTE="1aespinoza, post: 8709717, member: 654802"] That is alot of power, I mean like ALOT. You need some serious juice going to these kiddos! If you have that covered, you connect positive to positive then negative to negative on one sub. Then you connect that sub to one amp. Do the same with the other. Each sub will be 1ohm to it's own amp. Now connect rcas from radio to one amp in the input side. Then connect short rcas to the output side of that same amp. Finally, connect the other end of those short rcas to the input side of the other amp. You are done. Tune to your hearts content and bass on. You can also strap those amps but will need to gain match them. A tad bit on the complicated side. What is better than one bass knob? Two bass knobs! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Wiring dual 2ohm spearks to two strapped amps?
Top
Menu
Home
Refresh