Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Wiring Confirmation - Dual DVC Subs (2 Ohm) to Alpine PDR-M65 Mono in Custom Enclosure
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="hackths" data-source="post: 8705760" data-attributes="member: 679771"><p>Thanks! I did a resistance test last night on the speaker line coming to the amp and it tested out at 2 ohm (2.0-2.2) so that made me feel good. </p><p></p><p>After thinking through this a bit more too I think the fact that I soldered a "Y" in the speaker line rather then just connecting one sub to the next shouldn't matter, it just + or - power, it can sit anywhere in the line, not like sub 1 is doing any "processing" of the power. Just need the power to get to each sub.</p><p></p><p>My only concern now is my crap solder job, I just need more and more practice to avoid the big bulbous solder joint. Probably going to add some resistance there, but hopefully something I can move past for now and clean up later.</p></blockquote><p></p>
[QUOTE="hackths, post: 8705760, member: 679771"] Thanks! I did a resistance test last night on the speaker line coming to the amp and it tested out at 2 ohm (2.0-2.2) so that made me feel good. After thinking through this a bit more too I think the fact that I soldered a "Y" in the speaker line rather then just connecting one sub to the next shouldn't matter, it just + or - power, it can sit anywhere in the line, not like sub 1 is doing any "processing" of the power. Just need the power to get to each sub. My only concern now is my crap solder job, I just need more and more practice to avoid the big bulbous solder joint. Probably going to add some resistance there, but hopefully something I can move past for now and clean up later. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Wiring Confirmation - Dual DVC Subs (2 Ohm) to Alpine PDR-M65 Mono in Custom Enclosure
Top
Menu
Home
Refresh