Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
wiring amp to speakers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="hillzz22" data-source="post: 30618" data-attributes="member: 542721"><p>Hey, I was previously running 2 Bazooka EL1204 off a Kenwood KAC829 2 channel amp. I've since bought a JBL BP600.1 and hooked it up (killer amp by the way).</p><p></p><p>Anyways, what i was wondering is this: I would like to hook the old Kenwood amp up to either my front or rear speakers, or both. I am running Infinity 652i coax in the front and Alpine 1629 coax in the rear. Both speakers are 6.5 inch coax and the Infinity's have a highter RMS and peak rating. Would it be better to hook the front or rear or both speakers to the amp? Also, how would I go about doing this? The amp is 2 ohm stereo stable if that helps at all. Also, can I use the power and ground leads and RCA's that i ran for the other amp, or should i use a new ground, etc.? Thanks in advance for your help.</p><p></p><p>-Aaron</p></blockquote><p></p>
[QUOTE="hillzz22, post: 30618, member: 542721"] Hey, I was previously running 2 Bazooka EL1204 off a Kenwood KAC829 2 channel amp. I've since bought a JBL BP600.1 and hooked it up (killer amp by the way). Anyways, what i was wondering is this: I would like to hook the old Kenwood amp up to either my front or rear speakers, or both. I am running Infinity 652i coax in the front and Alpine 1629 coax in the rear. Both speakers are 6.5 inch coax and the Infinity's have a highter RMS and peak rating. Would it be better to hook the front or rear or both speakers to the amp? Also, how would I go about doing this? The amp is 2 ohm stereo stable if that helps at all. Also, can I use the power and ground leads and RCA's that i ran for the other amp, or should i use a new ground, etc.? Thanks in advance for your help. -Aaron [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
wiring amp to speakers
Top
Menu
Home
Refresh