Reply to thread

Message: <blockquote data-quote="shredder1" data-source="post: 8578470" data-attributes="member: 658920"><p>OK... enough is enough... LOL!.. Every time I enter a Sundown driver it defaults to a 4th order in Winisd... even if I choose a different alignment!.. I've tried to redo and change to several different Sundown drivers but it always happens!... IDK.. is there a value that I shouldn't trust or maybe something I should do special when entering Sundown drivers?... Every other manufacturer works out fine and models nicely but with the Sundown drivers I get a division by zero message then a 4th order whether I choose it or not and finally the program starts with all these access violation messages and it will not let me open a new project until I exit the program and start over then I get the same B/S... not LOL!... Hope to hear any input good or bad!</p></blockquote><p></p>

Top