Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Will this work?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Fi-brations" data-source="post: 7477730" data-attributes="member: 636442"><p>I have 2 Fi Q 12s in a ported box about 4.4cuft(pre-fab box) and i want to go sealed, money is always an issue, but i dont mind paying for something that i need to do, but i look to save money where i can, so i was wondering if i could just cut the port off and seal up the inside L port hole? so the box is for 2 12s and has an L port on one side of the box. the port is 12 by 3 1/2, so i would have a small, roughly 4 inch piece of wood sticking into the box, but the inside hole would be sealed up, so essentially a sealed box, right? what do u all think? would this work?</p></blockquote><p></p>
[QUOTE="Fi-brations, post: 7477730, member: 636442"] I have 2 Fi Q 12s in a ported box about 4.4cuft(pre-fab box) and i want to go sealed, money is always an issue, but i dont mind paying for something that i need to do, but i look to save money where i can, so i was wondering if i could just cut the port off and seal up the inside L port hole? so the box is for 2 12s and has an L port on one side of the box. the port is 12 by 3 1/2, so i would have a small, roughly 4 inch piece of wood sticking into the box, but the inside hole would be sealed up, so essentially a sealed box, right? what do u all think? would this work? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Will this work?
Top
Menu
Home
Refresh