Runnin the two RE SE12's right now, off of about 700rms each, and still want more. This box I have, I can easily take the front off and make a new cuttout for it so thats no problem. Its a tad under 5 cubes at 34hz I think. Getting a new amp and upgrading electrical is definately planned, so I'm just looking for something thats a bit louder
Shall I go with two better 12's (thinking SX's if I do this)
Three 10's (Prolly SE, or SX's)
Or, one 15 (BTL, MT, HDC3, whatever's the loudest).
Most of those shall do well in that box (can't fit 4 10's in it, not a big enough front, already tried that), but just looking to see what I should do.
The three 10's will give me weird ohm's, an the 12's are just kinda boring (want more low, although these get down), I'd have no problem going with a single 15, but I want to make sure it's louder than these. The two 12's have more cone area than the 15 (and the 10's more than any I listed), but I'm thinking the power should make up for it.
Shall I go with two better 12's (thinking SX's if I do this)
Three 10's (Prolly SE, or SX's)
Or, one 15 (BTL, MT, HDC3, whatever's the loudest).
Most of those shall do well in that box (can't fit 4 10's in it, not a big enough front, already tried that), but just looking to see what I should do.
The three 10's will give me weird ohm's, an the 12's are just kinda boring (want more low, although these get down), I'd have no problem going with a single 15, but I want to make sure it's louder than these. The two 12's have more cone area than the 15 (and the 10's more than any I listed), but I'm thinking the power should make up for it.