Reply to thread

Message

<blockquote data-quote="Winter_C" data-source="post: 6310014" data-attributes="member: 613961">Ok, tried this once and i got some decent feedback, but going to try again now that i know a little bit more about what i can afford...The ride: 1974 Ford Pinto (hatchback)stock alternator, stock battery, 4Ga wiring...ok so here it goes, i got (2) Rockford Fosgate Dual 4 ohm p3&#039;s on a kicker KX1200.1...with custom built box tuned to like 39ish hz and about 5 cubes...i only hit a 139.6...not happy...so now i am looking for something biggerBudget: ~700 cash+ current system...do i sell what i got and start over? or do i add to it? like 2 more p3&#039;s and another amp?I want to start competing in more SPL events...and standing a chance, best with this was 3rdas far as electrical goes, need to get a red top, think i got 1 found...and i think i am going to run 1/0 ga wire...not going to buy high-performance alt because this motor is original and not staying in forever..not throwing few hundred into it for a year of noise..i was told i could put a smaller pully on it possibly and increase output, thoughts?What do you guys think i should do? and with your suggestions can u give me a idea on what you think i may hit with it?Btw: if possible, could u list prices of stuff u suggest? no big deal...but would tell me kinda what your setup suggestoin would cost</blockquote>

[QUOTE="Winter_C, post: 6310014, member: 613961"] Ok, tried this once and i got some decent feedback, but going to try again now that i know a little bit more about what i can afford... The ride: 1974 Ford Pinto (hatchback) stock alternator, stock battery, 4Ga wiring... ok so here it goes, i got (2) Rockford Fosgate Dual 4 ohm p3's on a kicker KX1200.1...with custom built box tuned to like 39ish hz and about 5 cubes...i only hit a 139.6...not happy...so now i am looking for something bigger Budget: ~700 cash+ current system...do i sell what i got and start over? or do i add to it? like 2 more p3's and another amp? I want to start competing in more SPL events...and standing a chance, best with this was 3rd as far as electrical goes, need to get a red top, think i got 1 found...and i think i am going to run 1/0 ga wire...not going to buy high-performance alt because this motor is original and not staying in forever..not throwing few hundred into it for a year of noise..i was told i could put a smaller pully on it possibly and increase output, thoughts? What do you guys think i should do? and with your suggestions can u give me a idea on what you think i may hit with it? Btw: if possible, could u list prices of stuff u suggest? no big deal...but would tell me kinda what your setup suggestoin would cost [/QUOTE]

Verification