Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
what referance level do you guys use for test tones?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="devin171moto" data-source="post: 8702596" data-attributes="member: 679009"><p>i'm never going to clip because as I said my amp is a 3k. and the subs are 750rms a piece. they MIGHT take 2000 together because they are sunbdowns. I might get mechanical distortion or over excursion on low frequencies. but I wont clip. </p><p>as I understand at least.</p><p>I'm more worried about the potential for over excursion causing damage too far below port tune. </p><p>because even if i set it to its full potential at port tune. even if thats just 1200watts or so. </p><p>I could still over excurt at 23hz. I've never had a systen tuned this low so im looking for people with experience with balancing output across a decently wide and low frequency range. I.E. is it safe to just set them full tilt at port tune and dont worry about overexcursion too much above 23hz? or do i need to be extra careful.</p></blockquote><p></p>
[QUOTE="devin171moto, post: 8702596, member: 679009"] i'm never going to clip because as I said my amp is a 3k. and the subs are 750rms a piece. they MIGHT take 2000 together because they are sunbdowns. I might get mechanical distortion or over excursion on low frequencies. but I wont clip. as I understand at least. I'm more worried about the potential for over excursion causing damage too far below port tune. because even if i set it to its full potential at port tune. even if thats just 1200watts or so. I could still over excurt at 23hz. I've never had a systen tuned this low so im looking for people with experience with balancing output across a decently wide and low frequency range. I.E. is it safe to just set them full tilt at port tune and dont worry about overexcursion too much above 23hz? or do i need to be extra careful. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
what referance level do you guys use for test tones?
Top
Menu
Home
Refresh