Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
What material do I make ports out of?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Trixter" data-source="post: 419664" data-attributes="member: 542668"><p>Not until you start getting into large drivers that move a large amount of air. In that case i would go with a slot or square port. For something on the smaller side round ports work fine.</p><p></p><p>I have use PVC before and it works. All I did was glue and tube in place in the hole and added a few small, flat head screws in the inside of the port and screwed it into the MDF.</p></blockquote><p></p>
[QUOTE="Trixter, post: 419664, member: 542668"] Not until you start getting into large drivers that move a large amount of air. In that case i would go with a slot or square port. For something on the smaller side round ports work fine. I have use PVC before and it works. All I did was glue and tube in place in the hole and added a few small, flat head screws in the inside of the port and screwed it into the MDF. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
What material do I make ports out of?
Top
Menu
Home
Refresh