Reply to thread

Message

<blockquote data-quote="BOOMINGRANDPA" data-source="post: 8568284" data-attributes="member: 671921"><p>u should buy 50 ft and be done with it., cost u more buying smaller piece later, just get 2ga or bigger ofc.. u can use fused dist block, and ground block make sure u understand the wires from those are 1/2 size of wire from batt put blocks close to amps as u can within a foot or less maybe, so if u run 2 ga will need 2 short over sized 4ga from blocks, if u use 0 ga from batt use 2 2ga pieces to amps... fuses go by wire size i&#039;ll get u link to wire/fuse chart.. so wait to buy fuse holder until u sure on wire size., at amps&nbsp; if using smaller wire as i said u could maybe use 200amp fuse per amp (some peeps fuse buy the amp not wire) sou&nbsp; can use smaller one on kenwood as example, remember if u use fuse to small worse that will happen is fuse will blow which is y it&#039;s there but if u use fuse to big as my friend did with cab before he upgraded his wire he melted wire, fuse to big can&#039;t hurt amps and car..&nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;&nbsp; just scroll 1&quot; down u see chart&nbsp; &nbsp;&nbsp; <a href="http://bdfuses.com/fusesnwires.php" target="_blank">http://bdfuses.com/fusesnwires.php</a></p></blockquote><p></p>

[QUOTE="BOOMINGRANDPA, post: 8568284, member: 671921"] u should buy 50 ft and be done with it., cost u more buying smaller piece later, just get 2ga or bigger ofc.. u can use fused dist block, and ground block make sure u understand the wires from those are 1/2 size of wire from batt put blocks close to amps as u can within a foot or less maybe, so if u run 2 ga will need 2 short over sized 4ga from blocks, if u use 0 ga from batt use 2 2ga pieces to amps... fuses go by wire size i'll get u link to wire/fuse chart.. so wait to buy fuse holder until u sure on wire size., at amps if using smaller wire as i said u could maybe use 200amp fuse per amp (some peeps fuse buy the amp not wire) sou can use smaller one on kenwood as example, remember if u use fuse to small worse that will happen is fuse will blow which is y it's there but if u use fuse to big as my friend did with cab before he upgraded his wire he melted wire, fuse to big can't hurt amps and car.. just scroll 1" down u see chart [URL="http://bdfuses.com/fusesnwires.php"]http://bdfuses.com/fusesnwires.php[/URL] [/QUOTE]

Verification