Reply to thread

Message: <blockquote data-quote="BrianChia" data-source="post: 4091720" data-attributes="member: 576132">there's any easy way to make a fence/jig:Get a 2x4 and glue/screw it into a piece of 1/4" or 1/2" plywood or MDF, leaving a free end of just MDF that is about the width of the saw's boot. Then clamp down the sheet of wood and with the saw calibrated/aligned properly, rip down the sheet along the 2x4. Do the same thing on the other side, but cut along the other side of the boot (the narrower side). Now you can easily line up the fence with your cutting line since the blade will cut exactly where the edge of the MDF or plywood sheet is, and you can use either side of the boot to line it up.</blockquote>

Top