Reply to thread

Message: <blockquote data-quote="Savag3" data-source="post: 6396181" data-attributes="member: 607534"><p>ok i see ,  so if the port is 4" then the two back folds should be 2" . . i could do driver side i was just thinking that center ported would give them equal run to the port as I can not stack the 18's vertical evenly (heigth issue)  due you think if i positioned them diagonal from each other and did driver side it would be ok ? (have seen that design a few times)</p></blockquote><p></p>

Top