Reply to thread

Message

<blockquote data-quote="HollowHills" data-source="post: 8676582" data-attributes="member: 676633">I have a Memphis Audio PRX1000.1 powering two Sundown EV3 10&#039;S. Subs are wired to a 1 ohm load. So the issue I keep have reaccuring is the amp will suddenly quit providing output to the subs, when this happens I can reach back and literally just touch the amp with my hand or even just a finger tip and output comes back and subs start playing.  The blue status light never changes to red or cuts off or anything just stays blue as if everything is fine. Amp isn&#039;t hot to the touch, no popping or chirping or anything issues with the sound when it is playing.  There is no pattern as to when the issue occurs. I could be sitting still in my drive way this it just cuts off, driving down the road, music up loud, or music playing on low. Then just reach back and touch it and they kick back on. I&#039;ve also noticed this issue while adjusting knobs on the amp, like I&#039;ll tweek the LPF and it&#039;ll stop, touch the knob again with the tip of the screwdriver or something and it&#039;ll kick back on. It&#039;s extremely annoying and this is my second amp being that I exchanged the one right before it (same make and model amp) because it had issues. I know it&#039;s got good ground I recently just added a new dedicated grounding post just for it. So my question is, has anyone had similar issues I&#039;m having before with this or any other type of amp?  If so did they ever figure out and/or solve the issue? </blockquote>

[QUOTE="HollowHills, post: 8676582, member: 676633"] I have a Memphis Audio PRX1000.1 powering two Sundown EV3 10'S. Subs are wired to a 1 ohm load. So the issue I keep have reaccuring is the amp will suddenly quit providing output to the subs, when this happens I can reach back and literally just touch the amp with my hand or even just a finger tip and output comes back and subs start playing. The blue status light never changes to red or cuts off or anything just stays blue as if everything is fine. Amp isn't hot to the touch, no popping or chirping or anything issues with the sound when it is playing. There is no pattern as to when the issue occurs. I could be sitting still in my drive way this it just cuts off, driving down the road, music up loud, or music playing on low. Then just reach back and touch it and they kick back on. I've also noticed this issue while adjusting knobs on the amp, like I'll tweek the LPF and it'll stop, touch the knob again with the tip of the screwdriver or something and it'll kick back on. It's extremely annoying and this is my second amp being that I exchanged the one right before it (same make and model amp) because it had issues. I know it's got good ground I recently just added a new dedicated grounding post just for it. So my question is, has anyone had similar issues I'm having before with this or any other type of amp? If so did they ever figure out and/or solve the issue? [/QUOTE]

Verification