Reply to thread

Message

<blockquote data-quote="bikejunkie223" data-source="post: 1135373" data-attributes="member: 563147"><p>You can pull up the weatherstrip.trunk seal and put some rtv silicone sealant on the body and then place the seal back down on top of it, you may also need a seal. you cal also stream water down the back window and a fairly slow rate with the seal out, and the trunk lid open, there should be a channel around the trunk opening that guides the water away, see if it&#039;s pooling anywhere and check inside for the leak. Another way, if you know where the cabin pressure relief valve is (big vent lookin&#039; thing in the trunk, behind the liner somewhere) you can seal it off with rags and duct tape and turn on the vehicles blower motor on recirculate. With the relief valve sealed, pressure will build in the car and then you can go over the seams, seals, windshield, etc with a spray bottle filled with dawn hand soap and water. anywhere in blows bubbles is a leak that could leak water in. Hope that helps some. Water leaks are a matter of removing enough interior to see the bare metal and just putting water on it until you see where the water is entering. Good luck</p></blockquote><p></p>

[QUOTE="bikejunkie223, post: 1135373, member: 563147"] You can pull up the weatherstrip.trunk seal and put some rtv silicone sealant on the body and then place the seal back down on top of it, you may also need a seal. you cal also stream water down the back window and a fairly slow rate with the seal out, and the trunk lid open, there should be a channel around the trunk opening that guides the water away, see if it's pooling anywhere and check inside for the leak. Another way, if you know where the cabin pressure relief valve is (big vent lookin' thing in the trunk, behind the liner somewhere) you can seal it off with rags and duct tape and turn on the vehicles blower motor on recirculate. With the relief valve sealed, pressure will build in the car and then you can go over the seams, seals, windshield, etc with a spray bottle filled with dawn hand soap and water. anywhere in blows bubbles is a leak that could leak water in. Hope that helps some. Water leaks are a matter of removing enough interior to see the bare metal and just putting water on it until you see where the water is entering. Good luck [/QUOTE]

Verification