I have this in good condition MTX thunder in full working condition (hooked up now) The only thing is that it could use some new power/ground terminal screws. Its a good powerful amp, but its too much for what i want to use it for, and looking for something that works better at 1 ohm.
THUNDER1501D
• RMS Power measured at 12.5 Volts DC:
500 Watts x 1 into a 4 Ohm load with less than 2% Thd+N
1000 Watts x 1 into a 2 Ohm load with less than 2% Thd+N
• Dynamic Power measured at 14.4 Volts DC:
750 Watts x 1 into a 4 Ohm load
1500 Watts x 1 into a 2 Ohm load
• Signal to Noise Ratio: ≥100dB A-Weighted
• Damping Factor: >100
• Frequency Response: 20Hz-200Hz ± 3dB
• Maximum Input: 8Vrms
• Thunder EQ: Variable Bass Boost (0-18dB) centered at 40Hz
• Crossover: Variable 40Hz to 200Hz, 24dB/Octave Low Pass
• Dimensions: 17.8" x 9.75" x 2.1" (45.3cm x 24.8cm x 5.3cm)
Really would be looking for something like a kicker sx1250.1, kx1200, rockford 10001bd
LMK what you got, PM or post any questions
Sorry about no user name, i just grabed a pic off of my phone quick.
for now a pic is better then no pic.
P.S. The amp has never been opened, seal is not broken
THUNDER1501D
• RMS Power measured at 12.5 Volts DC:
500 Watts x 1 into a 4 Ohm load with less than 2% Thd+N
1000 Watts x 1 into a 2 Ohm load with less than 2% Thd+N
• Dynamic Power measured at 14.4 Volts DC:
750 Watts x 1 into a 4 Ohm load
1500 Watts x 1 into a 2 Ohm load
• Signal to Noise Ratio: ≥100dB A-Weighted
• Damping Factor: >100
• Frequency Response: 20Hz-200Hz ± 3dB
• Maximum Input: 8Vrms
• Thunder EQ: Variable Bass Boost (0-18dB) centered at 40Hz
• Crossover: Variable 40Hz to 200Hz, 24dB/Octave Low Pass
• Dimensions: 17.8" x 9.75" x 2.1" (45.3cm x 24.8cm x 5.3cm)
Really would be looking for something like a kicker sx1250.1, kx1200, rockford 10001bd
LMK what you got, PM or post any questions
Sorry about no user name, i just grabed a pic off of my phone quick.
for now a pic is better then no pic.
P.S. The amp has never been opened, seal is not broken
