Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
total power loss
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Stewie63" data-source="post: 8795791" data-attributes="member: 686234"><p>Help here I'm at my wits end! I have a 14 Jeep Wrangler that I had a shop install my Boss BV9384NV head unit. It was installed with the correct Crux CR-26 harness to factory connection. Several times after the vehicle has been shut off the head unit will not power on upon restart. In order to get it to work once again I have to pull the dash apart unclip the crux harness and clip it back together again. It then works for a while. So things that I have checked: Fuses all good, Battery voltage good at Yellow and Red wires more than 12volts, Ground good as well all checked with my multimeter. So I just downloaded the Crux Flasher and flashed the box last Saturday because Crux said it would fix this issue. Well obviously it did not fix it. I lose memory and all functions. I am probably going to bypass the yellow and Red wires and go a different route as that's all I can think to try at this point. Anyone have a better answer?</p></blockquote><p></p>
[QUOTE="Stewie63, post: 8795791, member: 686234"] Help here I'm at my wits end! I have a 14 Jeep Wrangler that I had a shop install my Boss BV9384NV head unit. It was installed with the correct Crux CR-26 harness to factory connection. Several times after the vehicle has been shut off the head unit will not power on upon restart. In order to get it to work once again I have to pull the dash apart unclip the crux harness and clip it back together again. It then works for a while. So things that I have checked: Fuses all good, Battery voltage good at Yellow and Red wires more than 12volts, Ground good as well all checked with my multimeter. So I just downloaded the Crux Flasher and flashed the box last Saturday because Crux said it would fix this issue. Well obviously it did not fix it. I lose memory and all functions. I am probably going to bypass the yellow and Red wires and go a different route as that's all I can think to try at this point. Anyone have a better answer? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
total power loss
Top
Menu
Home
Refresh