Reply to thread

Message

<blockquote data-quote="BrianChia" data-source="post: 4417571" data-attributes="member: 576132"><p>The ideal would be to test the woofer and redesign the enclosure and crossover from scratch. This can be expensive and time consuming if you don&#039;t have the proper tools, and may not be worth the effort for the given drivers. So yeah you can probably just use the same size enclosure and ports. I doubt the woofers can move enough air to produce port noise from the 2&quot; tubes anyway. If you have extra materials you could try a few different boxes (I&#039;d try a little larger and tune a little lower) and see how it affects output. As far as the crossover, again, a true redesign would require driver testing, but you could also figure out the crossover point and try a steeper slope and/or higher quality components and see if there is a difference. At least throw a coil on the woofer if you can. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif</p></blockquote><p></p>

[QUOTE="BrianChia, post: 4417571, member: 576132"] The ideal would be to test the woofer and redesign the enclosure and crossover from scratch. This can be expensive and time consuming if you don't have the proper tools, and may not be worth the effort for the given drivers. So yeah you can probably just use the same size enclosure and ports. I doubt the woofers can move enough air to produce port noise from the 2" tubes anyway. If you have extra materials you could try a few different boxes (I'd try a little larger and tune a little lower) and see how it affects output. As far as the crossover, again, a true redesign would require driver testing, but you could also figure out the crossover point and try a steeper slope and/or higher quality components and see if there is a difference. At least throw a coil on the woofer if you can. [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] [/QUOTE]

Verification