Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
To much power to sub
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="helotaxi" data-source="post: 1761094" data-attributes="member: 550915"><p>No a fully clipped signal is not DC it is an approximation of a sqaure wave with the crest of the square made from the summation of pretty much every harmonic of the basic signal.</p><p></p><p>As far as the cause goes, the output stage of the amp is trying to produce a signal of higher voltage than the rail voltage produced by the amp's power supply. The standard cause is overdriving the input of power stage either through to high a signal voltage from the source or overboosting the signal in the amps dedicated preamp stage.</p></blockquote><p></p>
[QUOTE="helotaxi, post: 1761094, member: 550915"] No a fully clipped signal is not DC it is an approximation of a sqaure wave with the crest of the square made from the summation of pretty much every harmonic of the basic signal. As far as the cause goes, the output stage of the amp is trying to produce a signal of higher voltage than the rail voltage produced by the amp's power supply. The standard cause is overdriving the input of power stage either through to high a signal voltage from the source or overboosting the signal in the amps dedicated preamp stage. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
To much power to sub
Top
Menu
What's new
Forum list
