Reply to thread

Message

<blockquote data-quote="518wrx" data-source="post: 5650447" data-attributes="member: 607433">ok im second guessing the equipment I have to see what amp im going to keep. I have a Memphis st1000.1d 1100watts at 1ohm and an Orion xtr900 .what i need to know is which amp would give the most spl and how many ohms i should run and how to run the wiring to the amp from the speakers&nbsp; (2 Memphis m3 154d 4ohm dvc 15&quot;)Orion specs:Xtreme 9002Output Power at 13.8V, 20Hz ∼ 20kHz,2 x 225W @ 4 ohms2 x 450W @ 2 ohms1 x 900W @ 4 ohms bridgeTHD:Freq. Response: 20Hz ∼ 20kHz (±0.25dB)Linear Bandwidth: 6Hz ∼ 50kHz (±3dB)S/N Ratio: &amp;gt;100dB (full bandwidth, rated power)Damping Factor: &amp;gt;400 (at output connector, full bandwidth)Fuse: 2 x 30ADimensions: 18&quot; x 10.25&quot; x 2.25&quot; (45.7cm x 26cm x 5.7cm)memphis specs:1100 @ 1ohm600@2ohm400@4ohmany help would be greatly appreciated, i need to get this going ASAP</blockquote>

[QUOTE="518wrx, post: 5650447, member: 607433"] ok im second guessing the equipment I have to see what amp im going to keep. I have a Memphis st1000.1d 1100watts at 1ohm and an Orion xtr900 . what i need to know is which amp would give the most spl and how many ohms i should run and how to run the wiring to the amp from the speakers (2 Memphis m3 154d 4ohm dvc 15") Orion specs: Xtreme 9002 Output Power at 13.8V, 20Hz ∼ 20kHz, 2 x 225W @ 4 ohms 2 x 450W @ 2 ohms 1 x 900W @ 4 ohms bridge THD: Freq. Response: 20Hz ∼ 20kHz (±0.25dB) Linear Bandwidth: 6Hz ∼ 50kHz (±3dB) S/N Ratio: >100dB (full bandwidth, rated power) Damping Factor: >400 (at output connector, full bandwidth) Fuse: 2 x 30A Dimensions: 18" x 10.25" x 2.25" (45.7cm x 26cm x 5.7cm) memphis specs: 1100 @ 1ohm 600@2ohm 400@4ohm any help would be greatly appreciated, i need to get this going ASAP [/QUOTE]

Verification