Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Taramps
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Ws6klr" data-source="post: 8701927" data-attributes="member: 679367"><p>Hello everyone. So I broke out my old school orion hcca250 and hcca225 but decided to use something newer and more efficient. I went with a Taranps MD 1200.1 1 ohm for my subs. I have two American Base 12 DVC 4 ohm Elites. The problem is at say 3/4 on my amp gain the amp lights for clipping and protect will flash or come on during loud higher base ( not deep smooth base all the time) and eventually it will go into protect. I am using a DS18 low to high converter off my factory amp. Could the gaines on the converter cause an issue if set incorrectly. Any info or advise would be appreciated.</p></blockquote><p></p>
[QUOTE="Ws6klr, post: 8701927, member: 679367"] Hello everyone. So I broke out my old school orion hcca250 and hcca225 but decided to use something newer and more efficient. I went with a Taranps MD 1200.1 1 ohm for my subs. I have two American Base 12 DVC 4 ohm Elites. The problem is at say 3/4 on my amp gain the amp lights for clipping and protect will flash or come on during loud higher base ( not deep smooth base all the time) and eventually it will go into protect. I am using a DS18 low to high converter off my factory amp. Could the gaines on the converter cause an issue if set incorrectly. Any info or advise would be appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Taramps
Top
Menu
What's new
Forum list
