Reply to thread

Message

<blockquote data-quote="Damion50" data-source="post: 7122609" data-attributes="member: 628135">Here are the stats on the 1200..&nbsp; Says 870 @ 2ohm&#039;s and the speakers are rated at 350rms..&nbsp; So I am pretty sure that should work, and save me almost 150 bucks..&nbsp; My only thing is there any special considerations for when I go to wire everything up.&nbsp; I mean I assume I can run both speakers off of a mono amp...&nbsp; But my thing is should I wire them in series or parallel..Cause if my understanding is right I can set the speakers to 4ohm then wire them parallel which would give me a total load of 2ohm&#039;s right ??Model AQ1200DFrequency Response 20Hz—250HzSignal to Noise Ratio 100dbLow Pass Crossover 24db / OctLow Pass Crossover Range 20Hz—200HzSubsonic Crossover Range 10Hz—50HzInput Sensitivity 0.2V—8VOutput Master / Input Slave Connection YesWorking Voltage 8V—16VEfficiency @ 4 ohm 84%Damping Factor Less than 150Fuse Rating 40Amp X 3 (Linked 240 Amp)Output Power 14.4V @ 1% THD 510X1 @ 4 ohm,870X1 @ 2 ohm,1200X1 @1 ohmOutput Power 14.4V @ 5% THD 1470X1 @ 1 ohmDash Mounted Remote IncludedDimensions 12.75″(L)x9.27″(W)x2.35″(H)</blockquote>

[QUOTE="Damion50, post: 7122609, member: 628135"] Here are the stats on the 1200.. Says 870 @ 2ohm's and the speakers are rated at 350rms.. So I am pretty sure that should work, and save me almost 150 bucks.. My only thing is there any special considerations for when I go to wire everything up. I mean I assume I can run both speakers off of a mono amp... But my thing is should I wire them in series or parallel.. Cause if my understanding is right I can set the speakers to 4ohm then wire them parallel which would give me a total load of 2ohm's right ?? Model AQ1200D Frequency Response 20Hz—250Hz Signal to Noise Ratio 100db Low Pass Crossover 24db / Oct Low Pass Crossover Range 20Hz—200Hz Subsonic Crossover Range 10Hz—50Hz Input Sensitivity 0.2V—8V Output Master / Input Slave Connection Yes Working Voltage 8V—16V Efficiency @ 4 ohm 84% Damping Factor Less than 150 Fuse Rating 40Amp X 3 (Linked 240 Amp) Output Power 14.4V @ 1% THD 510X1 @ 4 ohm, 870X1 @ 2 ohm, 1200X1 @1 ohm Output Power 14.4V @ 5% THD 1470X1 @ 1 ohm Dash Mounted Remote Included Dimensions 12.75″(L)x9.27″(W)x2.35″(H) [/QUOTE]

Verification