Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Subwoofers
Subwoofer "Rattle"...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Heathen" data-source="post: 8715559" data-attributes="member: 680849"><p>One end was still attached to the cone, the other was still attached to the terminal. It was severed/crushed in between. They had made a crude attempt at repair with a bulky crimp, but the wire had since been pulled out.</p><p></p><p>I removed the crimp, stripped the insulation back a little, splayed the strands and tried to gently intertwine. Then I put a drop of flux and soaked in some solder. I've also put a decent heatshrink put over the wound.</p><p></p><p>Primitive attempt, but it would defeat the purpose of finding a cheap stand-in sub if I were to pay for a pro repair.</p><p></p><p>Hopefully it will hold up.</p></blockquote><p></p>
[QUOTE="Heathen, post: 8715559, member: 680849"] One end was still attached to the cone, the other was still attached to the terminal. It was severed/crushed in between. They had made a crude attempt at repair with a bulky crimp, but the wire had since been pulled out. I removed the crimp, stripped the insulation back a little, splayed the strands and tried to gently intertwine. Then I put a drop of flux and soaked in some solder. I've also put a decent heatshrink put over the wound. Primitive attempt, but it would defeat the purpose of finding a cheap stand-in sub if I were to pay for a pro repair. Hopefully it will hold up. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Subwoofers
Subwoofer "Rattle"...
Top
Menu
Home
Refresh